Jedem, der die Prüfungsunterlagen und Software zu Network Appliance NS0-163 (Network Appliance Data Protection Solutions) von Pass4Test.de nutzt und die IT Zertifizierungsprüfungen nicht beim ersten Mal erfolgreich besteht, versprechen wir, die Kosten für das Prüfungsmaterial 100% zu erstatten.
Das Expertenteam von Pass4Test hat neuerlich das effiziente kurzfriestige Schulungsprogramm zur Network Appliance NS0-163 Zertifizierungsprüfung entwickelt. Die Kandidaten brauchen an dem 20-tündigen Kurs teilnehmen, dann können sie neue Kenntnisse beherrschen und ihre ursprüngliches Wissen konsolidieren und auch die Network Appliance NS0-163 Zertifizierungsprüfung leichter als diejenigen, die viel Zeit und Energie auf die Prüfung verwendet, bestehen.
Unser Pass4Test ist eine fachliche Website, die Prüfungsmaterialien für zahlreiche IT-Zertifizierungsprüfung bieten. Unser Pass4Test wird den vielen IT-Fachleuten zum Berufsaufstieg verhelfen. Die Kraft unserer Eliteteams ist unglaublich. Sie können die Examensübungen-und antworten für die Network Appliance NS0-163 Zertifizierungsprüfung teilweise als Probe umsonst herunterladen, so dass Sie die Glaubwürdigkeit vom Pass4Test testen können.
Exam Code: NS0-163
Prüfungsname: Network Appliance (Network Appliance Data Protection Solutions)
Die Schulungsunterlagen zur Network Appliance NS0-163 Zertifizierungsprüfung von Pass4Test werden die größten Erfolgsquote erzielen. Naben den Büchern sind heutztage das Internet als ein Wissensschatz angesehen. In Pass4Test können Sie Ihren Wissensschatz finden. Das ist eine Website, die Ihnen sehr helfen können. Sie werden sicher komplizierte Übungen treffen, Unser Pass4Test wird Ihnen helfen, die Prüfung ganz einfach zu bestehen, weil es alle notwendigen Kenntnisse zur Network Appliance NS0-163 Zertifizierungsprüfung enthält.
NS0-163 prüfungsfragen Demo kostenlos downloden: http://www.pass4test.de/NS0-163.html
NO.1 Which command or procedure would you use to undo a volume SnapRestore operation?
A. snap restore -r <vol/snapshotname> vol <path_and_vol_name>
B. snap revert -s <vol/snapshotname> vol <path_and_vol_name>
C. snap restore undo vol <path_and_vol_name>
D. You cannot undo a SnapRestore operation at the volume level.
Answer: D
Network Appliance testantworten NS0-163 NS0-163 NS0-163 NS0-163 originale fragen
NO.2 Which three /etc/snapmirror.conf entries will support synchronous or semi-synchronous SnapMirror?
(Choose three.)
A. FilerA:source_vol FilerB:destination_vol - sync
B. FilerA:source_vol FilerB:destination_vol - 0-55/5 * * *
C. FilerA:source_vol FilerB:destination_vol outstanding=3s sync
D. FilerA:source_vol FilerB:destination_vol visibility_interval=1hr, outstanding=3ms, cksum=crc32 sync
Answer: ACD
Network Appliance zertifizierungsantworten NS0-163 zertifizierungsantworten NS0-163 prüfungsunterlagen
NO.3 Which is true of the SnapVault backup of NetApp storage system?
A. The file is the basic unit for SnapVault backup destination.
B. The qtree is the basic unit for SnapVault backup destination.
C. The volume is the basic unit of SnapVault backup destination.
D. The directory is the basic unit for SnapVault backup destination.
Answer: B
Network Appliance echte fragen NS0-163 NS0-163 NS0-163 testantworten
NO.4 Which option will allow a storage system to SnapMirror from this source system?
A. snapmirror.access <destination_filer>
B. snapmirror.destination <destination_filer>
C. options snapmirror.allow host = <destination_filer>
D. options snapmirror.access host = <destination_filer>
Answer: D
Network Appliance NS0-163 NS0-163 prüfung
NO.5 What is the correct format for the scheduling component of a SnapVault schedule?
A. YYYY-MM-DD
B. crontab format
C. cnt[@day_list][@hour_list]
D. List of dates in ISO Date format
Answer: C
Network Appliance dumps NS0-163 NS0-163 NS0-163 prüfungsfrage
NO.6 Data ONTAP uses inodes in an active file system to reference ___________.
A. qtrees
B. disk blocks
C. file segments
D. Snapshot copies
Answer: B
Network Appliance NS0-163 originale fragen NS0-163
NO.7 Which Data ONTAP option sets system-wide throttling for all transfers?
A. options transfer.wide.enable
B. options transfer.throttle.enable
C. options replication.wide.enable
D. options replication.throttle.enable
Answer: D
Network Appliance NS0-163 NS0-163
NO.8 Which two choices are used to configure a semi-synchronous SnapMirror relationship? (Choose two.)
A. throttle
B. visibility interval
C. outstanding=3s in DOT 7.2
D. using option semi-sync in DOT 7.3 and higher
Answer: CD
Network Appliance NS0-163 dumps NS0-163 zertifizierungsfragen
NO.9 Assume fabric-attached MetroCluster using hardware disk ownership. If the local node has its FC HBA
connected to switch bank 1, it owns the disks connected to switch bank ___.
A. 1
B. 2
C. 3
D. 4
Answer: B
Network Appliance NS0-163 NS0-163 echte fragen
NO.10 Which statement applies to the Open Systems SnapVault Free Space Estimator utility?
A. This utility run automatically after each transfer.
B. This utility must be enabled on the secondary storage system.
C. This utility determines if there is sufficient disk space available on the primary to perform an OSSV
transfer.
D. This utility determines if there is sufficient disk space available on the secondary to perform an OSSV
transfer.
Answer: C
Network Appliance NS0-163 NS0-163
NO.11 Before enabling an active/active configuration, you should verify and compare the configuration of the
nodes. Which tool can perform this task?
A. cf-config-check.cgi script
B. cf status command on both nodes
C. clustercheck script
D. Release Comparison Tool
Answer: A
Network Appliance testantworten NS0-163 NS0-163 zertifizierungsfragen NS0-163
NO.12 The snapvault snap sched -x command is used to ____________.
A. schedule full backups
B. cancel scheduled backups
C. schedule baseline transfer
D. schedule incremental backups
Answer: D
Network Appliance prüfungsunterlagen NS0-163 prüfungsunterlagen NS0-163 zertifizierungsfragen NS0-163
NO.13 Which OSSV tool would you use to perform an OSSV unattended installation?
A. msipackage
B. svunattendossv
C. svconfigpackager
D. unattendpackager
Answer: C
Network Appliance NS0-163 zertifizierungsfragen NS0-163 NS0-163 prüfungsfrage NS0-163 zertifizierung NS0-163 prüfungsfragen
NO.14 The SnapVault secondary system allows you to keep a separate schedule of Snapshot copies from
your primary system.
A. True
B. False
Answer: A
Network Appliance NS0-163 NS0-163 NS0-163 prüfungsunterlagen NS0-163 prüfung
NO.15 Which system is recommended as a secondary system for SnapVault?
A. IS1200
B. DataFort
C. NearStore VTL
D. FAS with NearStore license
Answer: D
Network Appliance exam fragen NS0-163 prüfung NS0-163 echte fragen
NO.16 Which command creates a new SyncMirror aggregate, letting Data ONTAP select the disk drives?
A. aggr create aggrX -d 12
B. aggr create aggrX -m 12
C. aggr mirror aggrX -m 12
D. aggr mirror aggrX -n 12
Answer: B
Network Appliance prüfungsfrage NS0-163 echte fragen NS0-163 prüfungsunterlagen NS0-163 echte fragen NS0-163 NS0-163 echte fragen
NO.17 A NearStore license increases the amount of concurrent replication streams.
A. True
B. False
Answer: A
Network Appliance testantworten NS0-163 NS0-163 NS0-163 exam fragen
NO.18 The ONTAP SnapVault primary license on the target storage system is required for Open System
SnapVault.
A. True
B. False
Answer: B
Network Appliance NS0-163 NS0-163 NS0-163
NO.19 A snapshot is a frozen, read-only image of the entire Data ONTAP active file system that reflects the
state of the ____________ at the time the snapshot was created.
A. qtrees
B. volume
C. directory
D. storage system
Answer: B
Network Appliance NS0-163 zertifizierungsantworten NS0-163 zertifizierungsantworten NS0-163 dumps
NO.20 Which action will cause a currently in-sync SnapMirror relationship to fall out of sync?
A. Running snapmirror update on the source storage system
B. Running snapmirror release on the source storage system
C. Modifying the /etc/snapmirror.conf file for the relationship on the source storage system
D. Modifying the /etc/snapmirror.conf file for the relationship on the destination storage system
Answer: D
Network Appliance NS0-163 NS0-163 exam fragen NS0-163 NS0-163 exam fragen
Die Network Appliance NS0-163 Zertifizierungsprüfung ist eine Prüfung, die Fachkenntnisse und Fertigkeiten eines Menschen testet. Wenn Sie einen Job in der IT-Branche suchen, werden viele Personalmanager Sie nach den relevanten IT-Zertifikaten fragen. Wenn Sie das Network Appliance NS0-163 Zertifikat haben, können Sie sicher Ihre Wettbewerbsfähigkeit verstärken.
没有评论:
发表评论